Barry-Wehmiller Accraply 204RH, Руководство по эксплуатации и обслуживанию

Страница: 34 / 97

26 SECTION 1: SYSTEM OPERATION
1.5 Operating Procedures
1.5.1 Controls
Labeling Head controls can be found in the corresponding Operator’s manual in Section 4.
CONTROL PANEL:
ITEM TYPE DESCRIPTION SYSTEM REACTION & RECOVERY
E/STOP Palm Button The E/Stop is mechanically maintained
contact type (latching). Press this
button to dump the air and cut power
to conveyor/spacing wheel drives.
Machine stops. Power is cut to conveyor
and spacing wheel drives. Air is
dumped. Solid red light on light stack.
Solid red HEAD/DRIVE indicator light on
control panel. E/Stop must be released.
Alarm must be cleared by pressing the
Safety Reset button and the Alarm Reset
button before restarting.
SAFETY RESET Push Button Push to restore power and air after an
E/Stop or Interlock door open.
E/stops must be released and interlocked
door must be closed. After the SAFETY
RESET button is pressed, power and
air is restored to the system. Conveyor
and spacing wheels must be started by
pressing the START button.
START Push Button Push to start the conveyor and spacing
wheels.
System must not contain faults.
Conveyor and spacing wheels start.
Solid green light on light stack.
STOP Push Button Push to stop the conveyor and spacing
wheels.
System stops. Green light on light stack
turns off.
CHALLENGE
ON/OFF
Selector Switch Turn on to run the machine in
Challenge Mode. Turn off to run in
normal mode.
In challenge mode the yellow light on
the light stack is flashing. Labeler is
inhibited. Spacing wheels are stopped.
ALARM RESET Push Button After an alarm, the error must be
resolved and then this button must be
pressed to clear the alarm.
Press to clear the alarm. Red light on
light stack turns off. Alarm indicator
turns off. Once alarm is cleared, the
conveyor and spacing wheels must be
started by pressing the START button.
SENSOR/CYL Red Light Indicates there is an error with either a sensor or cylinder, or the eject bin is full.
See 1.5.3 Alarms.
INSPECTION Red Light Indicates there is an inspection error. See 1.5.3 Alarms.
HEAD/DRIVE Red Light Indicates there is an error with the labeling head or conveyor drive. See 1.5.3
Alarms.
OPERATING PROCEDURES