Barry-Wehmiller Accraply 204RH, Руководство по эксплуатации и обслуживанию

Страница: 31 / 97

23 SECTION 1: SYSTEM OPERATION
1.4.2 Label Position and Application
PRODUCT
FLOW
“Y” ADJUST
HAND WHEEL
PRODUCT
“X” CLAMP
“X”
“Y”
“Z1”
LABEL 2
“X” ADJUST
HAND WHEEL
“Y” CLAMP
LABEL 1
“Z2”
“X” POSITION:
The “X” position of the label on the product is adjusted by loosening the “X” clamp handle on the head mount and
turning the “X” adjust hand wheel. Once the adjustment has been made, tighten the clamp handle. This position will
be the same for label 1 and label 2.
“Y” POSITION:
The “Y” position of the labeling head should be set
so the dispense edge clears the top of the product
(the top reference of the product is determined by the
top hold rail). The wiper position should be adjusted
to apply sufficient pressure to the product to wipe on
the label. The “Y” position is adjusted by loosening
the “Y” clamp handle on the head mount and turning
the “Y” adjust hand wheel. Once the adjustment has
been made, tighten the clamp handle.
WIPER
DISPENSE
EDGE
PRODUCT
LABEL
“Z” POSITION:
The “Z1” position is for the first label. This position is adjusted by changing the “Start Offset” parameter setting in the
firmware. This setting creates a delay from the time the product signal is sent to the time the label is dispensed.
The “Z2” position is for the second label. This position is relative to the first label. This position is adjusted by
changing the “Label 2 Offset” parameter setting in the firmware.
Refer to the labeling head’s Manual for help on adjusting parameters.
SETUP AND AJDUSTMENTS