background image

Technical Support

 ■ (623) 580-8943 ■ [email protected]

IMPORTANT SAFEGUARDS

READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

   When using electrical equipment, basic safety precautions should always be followed including the following:

•  

DISCONNECT AC POWER SUPPLY BEFORE SERVICING.

•  Installation and servicing of this equipment should be performed by qualified service personnel only.

   

 

•  Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if 

       applicable.

•  Do not mount near gas or electrical heaters.

   •  Do not use outdoors. 

 

•  Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering 

 

    

by unauthorized personnel.

•  The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. 

•  Any modification or use of non-original components will void the warranty and product liability.

•  Do not use this equipment for other than intended use.

   

•  Allow battery to charge for 24 hours before first use. 

 

   

•  For use with metal enclosed wiring systems.

SAVE THESE INSTRUCTIONS!

CP-EX Series

Installation Instructions

 

10070224 

R

EV 1 - 07/20

   

1

800-533-3948 www.barronltg.com

Содержание Exitronix CP-EX Series

Страница 1: ...ns if applicable Do not mount near gas or electrical heaters Do not use outdoors Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by unauthorized personnel The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition Any modification or use of non original components will void the warranty and product li...

Страница 2: ...ote For large units the battery batteries may be shipped separate from the housing Install the battery batteries into the housing and make the appropriate battery connections 8 If desired remove appropriate chevrons Chevrons are made of 2 layers of self adhesive vinyl To remove manuver a utility knife underneath the desired chevron so that both layers of vinyl are penetrated Carefully peel the che...

Страница 3: ...emergency power from an external DC power supply is desired make connections as follows 120 277 or 347VAC External DC Supply White Common Purple Negative Black 120VAC Yellow 6 24VDC Orange 277VAC or Red 347VAC Note The AC and auxiliary power cannot be simultaneously live consult factory for a solution NiCad Battery Fig 5 AC Only Fig 6 With Battery Fig 7 Two Circuit Input 2CI 2CI Relay Generator UP...

Страница 4: ...supplied to the EXIT sign A flashing green LED indicates that the EXIT sign is undergoing a test A flashing red and green LED indicates that the battery is under high charge A red LED indicates whenever the Self diagnostics system has detected a fault condition Refer to the chart below when the red UNIT ALERT LED is blinking Test Button Features LED TEST Pressing and holding the test button for 3 ...

Отзывы: