Barox LT-PIGE-804GBTME Series, Руководство пользователя

Страница: 15 / 23

11
Wiring the Power Inputs
Please follow the below steps to insert the power wire.
Step 1.
Insert the positive and negative wires into the PWR1 (V1+, V1-) and PWR2 (V2+, V2-) contacts
on the terminal block connector as shown below in Figure 2.14.
Figure 2.14: Power Terminal Block
Step 2.
Tighten the wire-clamp screws to prevent the wires from loosening, as shown below in Figure
2.15.
Figure 2.15: Power Terminal Block
Note: Only use copper conductors, 60/75°C , tighten to 5 lbs.
The wire gauge for the terminal block should range between 18~20 AWG.