Barox Kommunikation RY-LGSP23-10G, Руководство пользователя, Страница: 220 / 383

barox Kommunikation
Publication date: Sept, 2015
Revision A1
209
2-19.11 Storm Control
The section allows user to configure the Storm control for the switch. There is a unicast storm
rate control, multicast storm rate control, and a broadcast storm rate control. These only affect
flooded frames, i.e. frames with a (VLAN ID, DMAC) pair not present on the MAC Address table.
The configuration indicates the permitted packet rate for unicast, multicast or broadcast traffic
across the switch
Web Interface
To configure the Storm Control Configuration parameters in the web interface:
1. Click Configuration, QoS, Storm Control Configuration
2. Evoke to select the frame type to enable storm control
3. Scroll to set the Rate Parameters
4. Click the save to save the setting
5. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
Figure 2-19.11: The Storm Control Configuration
Parameter description:

Frame Type :
The settings in a particular row apply to the frame type listed here: Unicast, Multicast or
Broadcast.

Enable :
Enable or disable the storm control status for the given frame type.

Rate :
The rate unit is packets per second (pps). Valid values are: 1, 2, 4, 8, 16, 32, 64, 128, 256, 512,
1K, 2K, 4K, 8K, 16K, 32K, 64K, 128K, 256K, 512K or 1024K. , 1024K, 2048K, 4096K, 8192K,
16384K or 32768K. , 1024K, 2048K, 4096K, 8192K, 16384K or 32768K.
The 1 kpps is actually 1002.1 pps.

Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved values.