Baroness TDA1200, Руководство по обслуживанию

Страница: 41 / 89

Tighten the left and right crank bracket with
bolts, nuts, and spring washers.
Install the upper housing Assy between the
crank brackets and drive in the crank shaft.
Install and temporarily tighten the disc
spring and cotter nut.
1
2
3
c8hvyh-006
Installation of gear box_006
1 Crank shaft
2 Crank bracket
3 Upper housing Assy
Caution
When removing and installing the crank
slotted nuts, be sure to secure the crank.
Secure the crank bracket by using a wood
block, etc. so that it does not rotate when
the nuts are loosen.
1
2
3
c8hvyh-007
Installation of gear box_007
1 Crank
2 Spanner
3 Wood block
Tighten the slotted nuts of the drive shaft
and crank shaft on the specified torque.
(See "Gear box layout" (Page 4-15) .)
Install the slotted pins.
11.
12.
13.
14.
15.
Front Roller Assy
Removal of front roller Assy
Install the sling to the front frame and lift it
by using a hoist, etc. so that the roller lifts
up off the ground.
1
2
3
jupx7f-001
Removal of front roller Assy_001
1 Front frame
2 Sling
3 Front roller
Loosen the hollow set securing the roller
shaft of the flange unit.
Follow the same steps to loosen the one on
the opposite side.
1
2
2
3
jupx7f-002
Removal of front roller Assy_002
1 Flange unit
2 Hollow set
3 Roller shaft
1.
2.
Operating Machine and Mower Units
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-19
Removal and installation of each section