Baroness SP160EB, Руководство по эксплуатации для владельца

Страница: 27 / 83

Charging of Battery
Danger Danger
While charging, explosive gas (hydrogen gas)
is generated. Charge batteries in a well-
ventilated area, where they will not get wet, for
example, from rain.
Danger Danger
The battery may explode if it is charged while
a battery plate is exposed.
Danger Danger
While charging, do not disconnect or connect
the plugs of the charger and not allow a tool to
cause a short circuit.
The battery may explode.
Important
Charge the battery with the charger included
with the machine.
Important
Leaving the battery discharged will shorten its
life.
Important
Before driving the machine, make sure that
the output plug of the charger is disconnected
from the connector on the main vehicle.
Charging procedures
Apply the parking brake, and then turn the
key switch to the "OFF" position.
Open the battery cover.
"Seat Platform" (Page 4-28) "Battery
Cover" (Page 4-28)
Inspect the battery.
"Inspection of Battery" (Page 4-4)
If the battery plate is exposed, supply
battery fluid up to the minimum level. 1.
2.
3.
Remove the water-proof cap from the
connector on the main vehicle, and then
plug in the output plug of the charger.
3
4
1
2
wc5fp4-001
Charging of Battery_001
1 Connector on main vehicle
2 Output plug
3 Charger
4 Input plug
Insert the input plug into the power supply
outlet (AC85
– 265 V, 45 – 65 Hz).
The LEDs will quickly flash from the top to
the bottom, and then charging begins after
approximately 10 seconds.
When charging is finished, the "AC On"
LED on the charger flashes (or lights up)
and the "100% Charge" LED lights up.
(The "AC On" LED flashes when the input
voltage is 100 V and lights up when it is
200 V.)
!
!
F
E
D
C
B
A
wc5fp4-002
Charging of Battery_002
A High charging current
B Low charging current
C 80% Charge
D 100% Charge
E AC On
F Fault
Disconnect the input plug of the charger
from the power supply outlet.
4.
5.
6.
7.
8.
Handling Instructions
SP160EB
Handling Instructions
Page 4-7
Inspections