Baroness SP05A, Руководство по эксплуатации для владельца

Страница: 64 / 76

Remove the bolts.
Remove the tire from the wheel mounting
seat.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the rear tires, reverse the
removing procedure.
Adjustment of Belt Tension
Warning
Be sure to stop the engine before adjusting
the belts.
Important
Before making sure of belt tension, rotate the
belt several times.
If the belt becomes slack due to frequent use, it
may jump or slip.
In addition, if it is overtightened, it may wear
prematurely.
If necessary, adjust it, and always check the
belt for appropriate tension.
Adjustment of Pump Drive Belt
The belt tension is appropriate when there
is approximately 10 mm (0.39 in) of slack
when the belt is pressed lightly by finger at
98 N (10 kgf) around the center section
between the belt pulleys (arrow in the
diagram).
Tighten the high nut until there is no
clearance between the spring cover and the
tension fulcrum fitting, and then lock it in
place with the nut.
9
8
7
3
5 4
2
1
6
vottpg-001
Adjustment of Pump Drive Belt_001
3.
4.
1.
2.
1 High nut
2 Spring cover
3 Tension fulcrum fitting
4 Nut
5 Belt
6 Spring
7 Tension pulley
8 Engine pulley
9 Pump pulley
Adjustment of Steering Chain
Excessive play with a loose steering chain may
stretch the chain further while you may feel a
heavy steering wheel with an excessively tight
chain and the chain and wheel may wear
prematurely.
Important
Make sure that the steering chain has the
specified amount of slack.
Open the front cover.
With the nuts on each end of the steering
chain, adjust the chain tension so that there
is approximately 5 mm (0.20 in) of slack.
1
A
3
4
2
2
y7bwwh-001
Adjustment of Steering Chain_001
1 Steering chain
2 Nut
3 Front wheel arm
4 Adjustment screw
A 5 mm (0.20 in)
After making adjustments, firmly secure the
nuts.
1.
2.
3.
SP05A
Maintenance
Page 5-12
Maintenance Work