Baroness LS62, Руководство по эксплуатации для владельца

Страница: 23 / 37

To increase cutting height:
Loosen cutting height adjustment nut
A, tighten cutting height adjustment nut
B, and then lower the front roller.
Use the cutting height gauge to
determine the cutting position, and
then firmly tighten cutting height
adjustment nut A.
To decrease cutting height:
Loosen cutting height adjustment nut
B, tighten cutting height adjustment nut
A, and then raise the front roller.
Use the cutting height gauge to
determine the cutting position, and
then firmly tighten cutting height
adjustment nut B.
5
6
2
A
7
3
4
1
9pu8ye-006
Cutting Height Adjustment_004
1 Reel cutter (cutting cylinder)
2 Front roller
3 Cutting height gauge
4 Bed knife (bottom blade)
5 Cutting height adjustment nut A
6 Cutting height adjustment nut B
7 Rear roller
A Cutting height
Repeat the same process at the opposite
side for the adjustment of cutting height.
Again, make sure that the cutting height is
at the required position by applying the
cutting height gauge to the front and rear
rollers at each edge of right and left of the
mower unit.
･
[1]
[2]
･
[1]
[2]
6.
7.
Adjustment of Cutter Adjustment Spring
If the diameter of the reel cutter (cutting
cylinder) becomes smaller, adjust the cutter
adjustment spring.
Adjust the blade engagement.
Loosen the pipe with cutter adjusting screw,
and then adjust the length of the spring coil
to approximately 40 mm (1.575 in.).
1
A
tv9pml-001
Adjustment of Cutter Adjustment Spring_001
1 Pipe with cutter adjusting screw
A 40 mm (1.575 in.)
Adjustment of Reel Cover (Variable Type)
Note:
Depending on the specifications, this function
may not be available.
The angle of the reel cover can be adjusted.
The opening angle of the reel cover can be set
to one of three positions in 15-degree
increments.
Pull the left and right knobs securing the reel
cover in order to release it.
Secure the reel cover to a different hole in
the cover adjustment plate.
2
1
3
A
B
1qbdtn-005
Adjustment of Reel Cover (Variable Type)_001
1.
2.
1.
2.
Handling Instructions
LS62
・
LS66
Handling Instructions
Page 4-9
Adjustment before Work