Baroness LS62, Руководство по эксплуатации для владельца

Страница: 17 / 37

Roller
Inspection of Rollers
Bearing wear due to frequent use or bearing
damage caused by water infiltration may
prevent the roller from rotating smoothly.
Inspect the roller and, if necessary, replace
parts such as oil seals and bearings.
Make sure that there is no abrasion nor
adhesion of the roller.
Make sure that there is no wear of the roller
shaft.
Make sure that there is no wear nor
damage of the oil seal.
Make sure that there is no wear nor rust of
the bearing.
Make sure that there is no play in the roller
shaft.
CR brush
Inspection of CR Brush
Note:
Depending on the specifications, this function
may not be available.
Bearing wear due to frequent use or bearing
damage caused by water infiltration may
prevent the brush from rotating smoothly.
Inspect the brush and, if necessary, replace
parts such as bearings.
Make sure that there is no abrasion nor
adhesion of the brush.
Make sure that there is no wear of the
brush shaft.
Make sure that there is no abnormality in
the brush.
Make sure that there is no play in the fit of
the bearing and the housing.
Make sure that there is no play in the brush
shaft.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
Scraper
Inspection of Scraper
Inspection of Front Scraper
Note:
Depending on the specifications, this
function may not be available.
The operating efficiency may be reduced
due to frequent use, objects crushed during
operation, or damage during transportation.
Inspect the scraper, and replace any parts if
necessary.
Make sure that there is no damage nor
deformation of the scraper.
Make sure that there is no contact
between the scraper and roller.
Inspection of Rear Scraper (Wire Type)
Note:
Depending on the specifications, this
function may not be available.
The operating efficiency may be reduced
due to frequent use, objects crushed during
operation, or damage during transportation.
Inspect the scraper, and replace any parts if
necessary.
Make sure that there are no breaks nor
sagging in the scraper (wire).
Make sure that there is no contact
between the scraper and roller.
￭
1.
2.
￭
1.
2.
Handling Instructions
LS62
・
LS66
Handling Instructions
Page 4-3
Inspections