Baroness LM551, Руководство по обслуживанию, Страница: 18 / 213

Maintenance Standards
Adjusted Value
Item Adjusted Value Details
Mower stabilizer spring #1-5 140.0 mm (5.51 in) Spring total length
Stopper nut position
LS62/66,
LH62 #1, 4, 5 15.0 mm (0.59 in) Length from end of bolt to nut
#2, 3 40.0 mm (1.57 in) Length from end of bolt to nut
LH52
#1, 4, 5
15.0 mm (0.59 in)
30.0 mm (1.18 in): with
grass catcher attached
Length from end of bolt to nut
#2, 3 40.0 mm (1.57 in) Length from end of bolt to nut
Traveling pedal 148.0 mm (5.83 in)
The forward travel pedal height from
the floor
Pedal stopper 31.0 mm (1.22 in) Length of stopper bolt
Brake wire 3.0 mm (0.118 in) Play on brake caliper side
Throttle wire 1.0 mm (0.039 in) Clearance in engine side throttle wire
Toe angle
1.0 - 5.0 mm (0.039 - 0.20
in)
Difference between front track and rear
track of rear wheel (rear track > front
track)
Pivot stopper
1.0 mm (0.039 in)
Left and right steering angle (clearance
between kingpin stopper and stopper
bolt)
43.0 mm (1.70 in)
Top and bottom swing angle (length of
stopper bolt)
Proximity switch
Proximity switch /#1
mower
520.0 mm (20.47 in)
From ground to grease nipple position
of #1 mower connecting fitting
Adjustment of proximity switch reaction
position
Proximity switch /#2
mower
480.0 mm (18.90 in)
From ground to shaft center of #2
mower connecting fitting
Adjustment of proximity switch reaction
position
Proximity switch /#4
mower
Proximity switch /#5
mower
7° (LH62)
5° (LH52, LS62)
Up angle from where mower arm
contacts the roller section of the #4, 5
mower unit guide
Adjustment of proximity switch reaction
position
Proximity switch/
Parking brake
2 notches
Adjustment of proximity switch no-
reaction position
LM551
Maintenance Standards and Maintenance
Page 3-4
Maintenance Standards