Baroness LM551, Руководство по эксплуатации для владельца, Страница: 92 / 102

Start the engine, and then idle for several
minutes to bleed air from the system.
Stop the engine, and then allow the radiator
to cool.
Check if the coolant level in the reserve tank
is between "FULL" and "LOW", and then
supply coolant if necessary.
Close the hood.
Change of Hydraulic Oil
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When you change the hydraulic oil, be sure to
drain it into a container and discard it in
accordance with local laws and regulations.
Important
If the hydraulic oil emulsifies or if it becomes
even slightly less transparent, change the oil
immediately.
Important
Use Shell Tellus S2M46 (or equivalent) as
hydraulic oil.
Follow the steps below to remove the old oil.
Start and run the engine to warm up the
oil.
On a level surface, lower the mower units,
and then stop the engine.
Remove the drain plug of the hydraulic
tank and drain the old oil into a bowl.
Install the drain plug.
1
pfdche-015
Change of Hydraulic Oil_001
8.
9.
10.
11.
1.
[1]
[2]
[3]
[4]
1 Drain plug
Remove the tank cover.
Open the tank cap, and then pour new oil
from the fill port until the oil level reaches the
middle of the oil gauge on the hydraulic tank.
The hydraulic tank capacity is approximately
30.3 dm
3
(30.3 L).
1
2
3
dmhzyz-019
Change of Hydraulic Oil_002
1 Hydraulic tank
2 Tank cap
3 Oil gauge
Tighten the tank cap securely.
Start the engine, raise and lower the mower
units, and turn the steering wheel left and
right.
Move forward and reverse repeatedly
several times.
Raise the mower units and maintain that
position on a level surface, and then check
to see if the oil level is at the middle of the oil
gauge. If necessary, supply oil.
Check underneath the machine for hydraulic
oil leakage.
Install the tank cover.
2.
3.
4.
5.
6.
7.
8.
LM551
Maintenance
Page 5-28
Maintenance Work