Baroness LM551, Руководство по эксплуатации для владельца, Страница: 84 / 102

Adjustment of Brake
Danger Danger
If the brake wire is cut, the machine will be
unable to stop. This would be extremely
dangerous.
If the brake wire is cracked or damaged,
immediately replace it with a new one.
If the brake is not sufficiently effective, adjust
the brake wire.
Important
Adjust the play of the brake lever so that it is
as small as possible and the brakes do not
drag when the lever is released.
Adjust the brake by using the adjustment bolt
on the brake wire.
2
1
1
2
3
3
ulabms-013
Adjustment of Brake_001
1 Brake wire
2 Adjustment bolt
3 Lock nut
Stop the engine.
Remove the step cover.
Adjust the travel of the brake lever by
tightening the brake wire adjustment bolt.
If the brake lever play is too large, the
braking power will be decreased and the
brake pedal will be soft.
1.
2.
3.
･
If the brake lever play is too small, the
braking power will be increased and the
brake pedal will be hard.
4
1
2
3
nfzln9-025
Adjustment of Brake_002
1 Brake wire
2 Adjustment bolt
3 Lock nut
4 Brake lever
Start the engine.
Drive the machine to check the following.
Make sure that heat is not generated in
the brake area.
Make sure that the left and right brakes
are equally effective.
Danger Danger
It would be extremely dangerous and may
result in an unexpected accident if the left and
right brakes are not equally effective.
If the left and right brakes are not equally
effective, make fine adjustments by using the
adjustment bolts on the brake wires.
Break-in of Brakes
If the brake shoes or brake pads are worn,
replace them with new ones.
Immediately after replacement, drive to break
in the brakes if the effectiveness of the brakes
is low.
While driving, lightly operate the brakes to
break in the contact areas.
･
4.
5.
･
･
6.
LM551
Maintenance
Page 5-20
Maintenance Work