Baroness LM551, Руководство по эксплуатации для владельца, Страница: 61 / 102

Warning Buzzer
There are two warning buzzers, which
indicate four warnings.
Warning buzzer 1 & 2
Warning buzzer 3 & 4
Overheat Warning Buzzer
If the water temperature inside the engine
exceeds 110 degrees Celsius, a buzzer will
sound. (intermittent tone)
When the buzzer sounds, remove the load
from the engine, idle the machine for five
minutes, stop the engine, and then inspect
the machine and perform any necessary
maintenance.
Hydraulic Oil Level Warning Buzzer
If the oil level in the hydraulic tank
decreases by approximately 3.0 dm
3
(3.0 L)
from the specified level, a buzzer will
sound. (continuous tone)
When the buzzer sounds, remove the load
from the engine, idle the machine for five
minutes, stop the engine, and then inspect
the machine and perform any necessary
maintenance.
Engine Overload Warning Buzzer
If the traveling pedal is depressed and the
speed exceeds 12.0 km/h while the pedal
stopper is in the "OFF" position and the reel
cutters (cutting cylinders) are rotating, a
buzzer will sound. (intermittent tone)
When the buzzer sounds, adjust the speed
to 12.0 km/h or less.
Warning Buzzer for Traveling With Brake
Applied
If the traveling pedal is depressed while the
brake pedal is locked with the locking
pedal, a buzzer will sound. (continuous
tone)
When the buzzer sounds, firmly depress
the brake pedal to release the locking
pedal.
Hour meter
The hour meter is located in the operation
panel, and indicates the accumulated operation
time of the engine.
The number in black figures on a white
background is incremented every six minutes.
The number in white figures on a black
background is incremented every hour.
･
･
1.
2.
3.
4.
1/10 wheel
…
black figures on a white
background
Hour wheel
…
white figures on a black
background
10
1
2 1
uknn6v-001
Hour meter_001
1 1/10 wheel
2 Hour wheel
Travel of Machine
Traveling Procedure
Caution
Under any circumstances drive the machine at
such a speed that you can stop it immediately
for emergencies.
Caution
When traveling, be sure to push the reel
rotation switch to the "Stop" side and raise the
mower units.
Start the engine.
Raise all mower units.
Firmly depress the brake pedal to release
the locking pedal and release the brake
pedal.
Slowly depress the traveling pedal.
The machine starts traveling. 1.
2.
3.
4.
5.
Handling Instructions
LM551
Handling Instructions
Page 4-37
Travel of Machine