Baroness LM551, Руководство по эксплуатации для владельца, Страница: 43 / 102

Note:
Raise the lock nut to a position where it will
not interfere when the dial is turned.
6
5
4
3
2
1
8
7
1
2
3
96fzvf-002
Adjustment of Reel Rotation Control Valves_005
1 Dial
2 Lock nut
3 Indicating screw
Turn the dial clockwise until it stops.
Turn the dial counterclockwise to set it to the
appropriate position.
The amount that the dial is turned differs
depending on the mower unit.
When mower unit LS62 or LS66/LH62 is
installed:
Turn the dial counterclockwise three
times, then an additional 180 degrees.
Position "4" on the dial sticker should be
aligned with the center of the indicating
screw.
When mower unit LH52 is installed:
Turn the dial counterclockwise two times,
then an additional 45 degrees.
Position "1" on the dial sticker should be
aligned with the center of the indicating
screw.
5
1 2
3 4
96fzvf-003
Adjustment of Reel Rotation Control Valves_006
4.
5.
1 Dial
2 Lock nut
3 Indicating screw
4 Reel rotation label
Use the specialized wrench (accessory) to
tighten the lock nut for the dial.
Adjustment of Mower Stopper Pin
The mower stopper pin can prevent or allow
tilting of the mower units.
Adjust according to the operating conditions.
Fixed:
The mowing line while traveling straight
ahead is a straight line. (The mowing line is
easy to see.)
The mower units do not tilt while operating
on slopes, and incomplete mowing can be
reduced.
Released:
It is appropriate when turning while mowing
or it is easy to follow undulations.
On a level surface, lower all mower units.
Apply the parking brake, and then stop the
engine.
Adjust the position of the mower stopper pin,
and then insert the cotter pin.
To fix:
Insert the cotter pin into the upper hole in the
mower stopper pin.
4
3
1
2
famlj4-003
Adjustment of Mower Stopper Pin_001
1 Mower stopper pin
2 Cotter pin
3 Mower arm
4 Mower coupling
6.
･
･
･
1.
2.
3.
Handling Instructions
LM551
Handling Instructions
Page 4-19
Adjustment Before Operating