Baroness LM531, Руководство по эксплуатации для владельца, Страница: 86 / 96

Remove the reserve tank.
1
2
ouuoov-029
Change of Coolant_003
1 Reserve tank
2 Reserve tank cap
Open the reserve tank cap, and then drain
the coolant.
Install the reserve tank.
Clean the radiator with clean water (soft
water) to remove any debris or rust.
Drain all water from the radiator.
Follow the steps below to fill with coolant.
The coolant quantity, including the reserve
tank, is 6.0 dm
3
(6.0 L).
Install the drain plug.
Supply clean water (soft water) and
antifreeze into the radiator up to the
radiator cap opening.
Close the radiator cap.
Supply clean water (soft water) and
antifreeze into the reserve tank up to the
"FULL" mark.
Close the reserve tank cap.
Start the engine, and then idle for several
minutes to bleed air from the system.
Stop the engine, and then allow the radiator
to cool.
Check if the coolant level in the reserve tank
is between "FULL" and "LOW", and then
supply coolant if necessary.
Close the hood.
Change of Hydraulic Oil Filter
Change of Hydraulic Oil Line Filter
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
[4]
[5]
4.
5.
6.
7.
[1]
[2]
[3]
[4]
[5]
8.
9.
10.
11.
Important
When replacing the hydraulic oil filter, be sure
to drain the oil into a container and discard it
in accordance with local laws and regulations.
Important
If the hydraulic oil emulsifies or if it becomes
even slightly less transparent, change the oil
immediately.
Important
Use Shell Tellus S2M46 (or equivalent) as
hydraulic oil.
On a level surface, lower the mower units,
and then stop the engine.
Remove the old filter cartridge.
Lightly coat the packing of the new filter
cartridge with hydraulic oil, and then install
the cartridge.
Firmly tighten the filter cartridge by hand so
that the packing contacts the mounting
surface.
Then, tighten it an additional 1/2 turn.
1
ycfdh6-016
Change of Hydraulic Oil Line Filter_001
1 Cartridge filter
Supply hydraulic oil until it reaches the
specified level.
"Hydraulic Oil Supply" (Page 4-5)
Start the engine, and then after the
hydraulic oil has warmed up, stop the
engine.
Check underneath the machine for
hydraulic oil leakage.
1.
2.
3.
4.
5.
6.
7.
LM531
Maintenance
Page 5-18
Maintenance Work