Baroness LM331, Руководство по эксплуатации для владельца, Страница: 63 / 103

Procedure to Stop Engine
Set the traveling pedal to the neutral
position.
Apply the parking brake.
Set the reel rotation switch to the "Stop"
position.
Shift the throttle lever to the "Low speed"
position, and then warm up the engine for
1-2 minutes.
Lower all the mower units to the ground.
Switch the ignition key to the "OFF" position.
Make sure that the engine has stopped.
Parking and Stopping
Leaving the machine
Caution
If the brakes are not sufficiently effective, use
the wheel stoppers to secure the machine.
Caution
Never park the machine on a slope.
Park the machine on level ground.
Apply the parking brake.
Stop the engine.
Remove the ignition key.
Install the rubber cap to the key switch.
Leave the driver's seat.
Close the fuel cock of the fuel filter.
Close the fuel cock of the water separator.
Move
Traveling Procedure
Caution
Under any circumstances drive the machine at
such a speed that you can stop it immediately
for emergencies.
Caution
Since traveling on steep downward slopes,
wet surfaces and wet grassy downward
slopes in 3WD is dangerous, use 2WD.
Otherwise, the rear tires may slip and travel
control may be lost.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
8.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
Start the engine.
"Procedure to Start Engine" (Page 5-17)
Raise all mower units.
Depress the brake pedal to release the
parking brake.
Release the brake pedal.
Slowly depress the traveling pedal.
The machine starts traveling.
The machine stops with the traveling pedal
released and the brake pedal depressed. 1.
2.
3.
4.
5.
6.
7.
Handling Instructions
LM331
Handling Instructions
Page 5-19
Parking and Stopping