Baroness LM281, Руководство по эксплуатации для владельца

Страница: 80 / 92

Adjustment of Brake
Caution
If the brake wire is cut, the machine will be
unable to stop.
If the brake wire is cracked or damaged,
replace it with a new one immediately.
If the brake is not sufficiently effective, adjust
the brake wire.
Important
Adjust to reduce the play in the brake lever as
much as possible so that the brake does not
drag when the lever is released.
Adjust the brake by tightening the brake wire
adjustment bolt.
If there is too much play in the brake lever,
the braking power is reduced and the
brake pedal feel is light.
If there is too little play in the brake lever,
the braking power is increased and the
brake pedal feel is heavy.
3
4
2
1
nfzln9-002
Adjustment of Brake_001
1 Lock nut
2 Adjustment bolt
3 Brake wire
4 Brake lever
Start the engine and drive to check the
following.
Make sure that heat is not generated in
the brake area.
Make sure that the left and right brakes
are equally effective.
Caution
It may result in an unexpected accident if the
left and right brakes are not equally effective.
1.
･
･
2.
･
･
If the left and right brakes are not equally
effective, make fine adjustments with the
adjustment bolt on the brake wire.
Break-In of Brakes
If the brake shoes or brake pads are worn,
replace them with new ones.
Immediately after replacement, drive to break
in the brakes if the effectiveness of the brakes
is low.
While driving, lightly operate the brakes to
break in the contact areas.
Adjusting The Neutral Position of The
Piston Pump
Caution
Make sure not to touch rotating tires.
Caution
When adjusting the neutral position, pay close
attention to abrupt start of the machine.
Place the jacks beneath the jack-up points,
and then lift the machine until all the tires get
off the ground.
If the machine moves forward or backward
while the traveling pedals are released, they
are not set to the neutral position.
Follow the steps below to make adjustments.
Stop the engine.
Place the jacks beneath the jack-up points,
and then lift the machine off the ground.
Use stable jack stands, and raise the
machine until the tires lift off the ground.
"Jack-Up Points" (Page 5-5)
Start the engine, and rev it up to the
maximum rpm.
Adjust the neutral position.
If the front tires rotate forward, loosen the
lock nuts, then turn the front wheel rod to
shorten it.
3.
1.
2.
3.
4.
[1]
LM281
Maintenance
Page 5-18
Maintenance Work