Baroness LM2700, Руководство по обслуживанию

Страница: 32 / 325

Special Tool
Special tools list
No use of special tools is required.
General inspection and repair
Cooling system
Water-cooled Engine
Water cooling device consists of a water
jacket, radiator, water pump, thermostat,
cooling fan, radiator hose, etc. to maintain the
engine temperature at appropriate levels.
To prevent the engine from overheating,
always keep the radiator, oil cooler, radiator
cover, and the surface of related parts clean.
Note:
Refer to the Owner
’ s Operating Manual for the
cleaning frequency and procedure etc.
Warning
In case that the engine overheats, steam may
spout from the radiator or reserve tank, and
could cause burns.
Caution
Do not stop the engine abruptly.
First, shut off the load, then run a cooling
operation (such as idling), and then stop the
engine.
Important
If the radiator, oil cooler, or radiator cover is
dirty and you start the engine, the engine may
overheat and malfunction.
It may also cause malfunction of the hydraulic
system.
Important
Do not wash the engine using a washer.
Otherwise, water may enter the fuel system.
Move the machine to a level surface.
Apply the parking brake, stop the engine,
then remove the ignition key.
Warning
Never touch the engine or exhaust system.
Due to high temperatures, doing so could
cause burns.
Make sure that the engine is cool enough
before you start operation.
Caution
Make sure that the engine and radiator are
cool enough before you start operation.
Important
Rotate and loosen the cap slowly up to the
first stop, release all pressure, and then
rotate it further to remove it.
Open the radiator cap, and then check to
make sure that the coolant level is up to the
opening.
If a reserve tank is attached, check to make
sure that the coolant level is between the
"LOW" and "FULL" marks on the reserve
tank.
If the coolant levels in the radiator and the
reserve tank are insufficient, fill them with
clean water like tap water etc.
1.
2.
3.
4.
LM2700
Engine
Page 4-4 Special Tool