Baroness LM2700, Руководство по обслуживанию, Страница: 118 / 325

Installation of Front Wheel Motor
Caution
After the installation, check if there is no oil
leakage in each part.
Caution
See the list in "Tightening torques" (Page
3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Make sure of the installing locations of the
hydraulic hoses and do not install them at the
wrong locations.
Important
Replace O-rings on the adapter and other
parts with new ones.
Important
When you re-use the wheel motor or adopter,
completely remove the seal tape which
remains on the thread portion.
For installation, reverse the removing
procedure.
Removal of Rear Wheel Motor
Caution
Two people should work together on the
wheel motor since it is heavy.
Remove the rear wheel. (See "Removal of
Rear Wheel" (Page 7-18) .) 1.
Remove the wheel mounting base. (See
"Removal of Rear Wheel Mounting Base"
(Page 7-23) .)
Important
Before removing the hydraulic hose, check its
installation position.
Remove the three hydraulic hoses from the
wheel motor.
Install the screw caps to the hydraulic
hoses.
1
3
4
2
otacki-007
Removal of Rear Wheel Motor_001
1 Wheel motor
2 Hydraulic hose
3 Screw cap
4 Adapter
Remove the four bolts, spring washers, and
nuts, and then remove the wheel motor in
the direction of the arrow.
4
2
3
5
1
otacki-008
Removal of Rear Wheel Motor_002
2.
3.
4.
5.
LM2700
Hydraulic system
Page 5-64 Removal and installation of each section