Baroness LM2700, Руководство по обслуживанию

Страница: 110 / 325

Open the tank cap, and then pour new oil
from the fill port until the oil level reaches
the middle of the oil gauge on the hydraulic
tank.
The hydraulic tank capacity is
approximately 44.0 dm
3
(44.0 L).
1
dmhzyz-006
Change of Hydraulic Oil_002
1 Tank cap
Tighten the tank cap securely.
Start the engine, raise and lower the mower
units, and turn the steering wheel left and
right.
Move forward and reverse repeatedly
several times.
Raise the mower units and maintain that
position on a level surface, and then check
to see if the oil level is at the middle of the
oil gauge. If necessary, supply oil.
Check underneath the machine for oil
leakage.
Attach the left tank cover.
3.
4.
5.
6.
7.
8.
Timing for Raplacing Hydraulic Oil
Important
Contamination of hydraulic oil may cause
malfunction of the hydraulic system.
Periodically replace the hydraulic oil.
Timing for
replacing
First time
After 100 hrs of
operation
Second time
and later Every 500 hrs of
operation
Specified
hydraulic
oil
Shell Tellus S2M46 (or
equivalent)
Tank
capacity
44 L (11.62 US gallons)
Hydraulic oil filter
Replacement of Hydraulic Oil Filter
Remove the old cartridge filter
1
ycfdh6-005
Replacement of Hydraulic Oil Filter_001
1 Cartridge filter
Apply clean hydraulic oil on the packing of
the new cartridge filter.
Screw in the filter by hand until the packing
contacts the mounting surface.
Then tighten additional 1/2 turn from that
point.
After the installation, start the engine. After
the oil is warmed up, stop the engine and
then check that there is no oil leakage.
￭
1.
2.
3.
4.
LM2700
Hydraulic system
Page 5-56 Inspection and repair of each section