Baroness LM2700, Руководство по обслуживанию

Страница: 109 / 325

Hydraulic Oil Supply
Important
Do not mix different types of oil.
Important
Use Shell Tellus S2M46 (or equivalent) as
hydraulic oil.
If the oil level is low, follow the steps below
to supply oil.
Remove the left tank cover.
Open the tank cap and supply oil.
1
dmhzyz-006
Hydraulic Oil Supply_001
1 Tank cap
Tighten the tank cap securely.
Start the engine, raise and lower the mower
units, and turn the steering wheel left and
right.
Move forward and reverse repeatedly
several times.
Raise the mower units and maintain that
position on a level surface, and then check
to see if the oil level is at the middle of the
oil gauge. If necessary, supply oil.
Check underneath the machine for oil
leakage.
Attach the left tank cover.
1.
[1]
[2]
2.
3.
4.
5.
6.
Change of Hydraulic Oil
Warning
When you change the hydraulic oil, be sure to
drain it into a bowl and discard it in
accordance with local laws and regulations.
Caution
If the oil emulsifies or if it becomes even
slightly less transparent, change the oil
immediately.
Important
Use Shell Tellus S2M46 (or equivalent) as
hydraulic oil.
Follow the steps below to remove the old
oil.
Start and run the engine to warm up the
oil.
Remove the drain plug of the hydraulic
tank on a level surface, and drain the old
oil into a bowl.
1
2
pfdche-004
Change of Hydraulic Oil_001
1 Hydraulic tank
2 Drain plug
Wind new sealing tape on the drain plug,
and then attach it to the hydraulic tank.
Remove the left tank cover.
1.
[1]
[2]
[3]
2.
Hy
draulic system
LM2700
Hydraulic system
Page 5-55 Inspection and repair of each section