-26-
19. Attaching/detaching the mower unit
Be sure to install and remove the mower unit in a flat horizontal place. Stop the
engine unless it is necessary to move the attachment mounting base up and down or
to move the machine forward and backward.
19-1. Removal of mower unit
Remove the intermediate shaft belt cover and right crawler cover, and then
remove the belt that connects the machine and the mower unit.
Pull out 6 clip pin and remove the lock pin.
Set the cylinder single-/double-acting changeover switch in the "double-acting"
position, and lower the attachment mounting base.
After confirming that the hitch sections are separated, slowly move the machine
backward, and the operation is complete.
When jacking up the machine with hydraulic jacks, apply jacks to the jacking-up
points on the following drawing.
Attachment
mounting base
Hitch sections
Lock pin mounting hole
Mower unit
CAUTION
1
2
3
4
18-2. Jacking up
(Front side)
(Rear side)
Jacking-up points
Jacking-up points
Bottom view of Main frame
