Baroness GM2810A, Руководство по эксплуатации для владельца, Страница: 114 / 155

Replacement of Rear Tire
Removing rear tires
Follow the steps below to remove the rear
tire.
Loosen the bolts.
1
2
jnpvbf-001
Replacement of Rear Tire_001
1 Rear tire
2 Bolt
Securely place the jack beneath the jack-
up point below the rear wheel motor, and
then raise it until the tire lifts off the
ground.
"Jack-Up Points" (Page 6-2)
Remove the bolts.
Remove the tire from the wheel mounting
base.
Installing rear tires
Important
Tighten the bolts in the tightening order
(diagonally).
Important
Tighten the wheel mounting bolts on the
specified torque by using a torque wrench.
For installing the rear tire, reverse the
removing procedure.
1.
[1]
[2]
[3]
[4]
2.
Adjustment of Belt Tension
Warning
Be sure to stop the engine before adjusting
the belts.
Important
Before making sure of belt tension, rotate the
belt several times.
If the belt becomes slack due to frequent use, it
may jump or slip.
In addition, if it is overtightened, it may wear
prematurely.
If necessary, adjust it, and always check the
belt for appropriate tension.
Adjustment of Fan Belt
Press the middle of the belt with your finger
to check the belt tension.
The belt tension is appropriate when the
belt slacks by approximately 7.0 - 9.0 mm
(0.28 - 0.35 in) when you apply a force of
98 N (10 kgf) to the belt at the middle point
between the pulleys.
If the belt tension is inappropriate, loosen
bolts A and B (that affix the alternator), and
then move the alternator to adjust the
tension.
1
2
3
4
5
A
mzdn8n-003
Adjustment of Fan Belt_001
1 Fan belt
2 Blade
3 Alternator
4 Bolt A
5 Bolt B
A 7.0 - 9.0 mm (0.28 - 0.35 in)
1.
2.
GM2810A
Maintenance
Page 6-14
Adjustment and Replacement