Baroness FS900, Руководство по эксплуатации для владельца

Страница: 58 / 95

Procedure to Stop Engine
Lower the bucket to its lowest position.
Raise the brush frame.
Set the stop valve to the "STOP" position.
Set the traveling pedal in neutral position.
Apply the parking brake.
Move the throttle lever to "Low", and
continue idling for 1-2 minutes.
Switch the ignition key to the "OFF" position.
Make sure that the engine has stopped.
Parking and Stopping
Leaving The Machine
Caution
If the brakes are not sufficiently effective, use
the wheel stoppers to secure the machine.
Caution
Never park the machine on a slope.
Park the machine on level ground.
Apply the parking brake.
Stop the engine.
Remove the ignition key.
Step off the machine.
Close the fuel cock.
Move
Traveling Operation
Warning
Do not travel with the bucket raised.
Caution
Under any circumstances drive the machine at
such a speed that you can stop it immediately
for emergencies.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
Start the engine.
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
6.
1.
Make sure that the brush frame is raised.
Make sure that the stop valve is set to the
"STOP" position.
Release the parking brake.
Slowly depress the traveling pedal.
The machine starts traveling.
The machine stops slowly when the foot
leaves the traveling pedal.
Operations
Collecting Operation
Danger Danger
Do not perform collecting operation on a slope
with an angle of gradient that is greater than
10 degrees.
Caution
Make sure that the bucket lid is closed.
Caution
Collection work must be performed at an
appropriate speed for the site and location.
When collecting over bumpy surfaces, keep
the engine rpm steady, and slow down the
speed.
Caution
Before beginning collection work, be sure to
perform a safety check of the intended work
area.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
Start the engine.
Set the stop valve to the "OPEN" position.
Make sure that the brush frame is raised.
Release the parking brake.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
FS900
Handling Instructions
Page 5-18
Parking and Stopping