Barnstead Mega-Pure Series 798, Инструкция по эксплуатации и список запасных частей

Страница: 18 / 32

18
Plug electrical power cord into appropriate receptacle.
Refer to Figure 1, page 2 for referenced locations.
1. Close drain clamp "G" on bottom of boiler "I."
2. Open valve at tap water source and treated water
source if so installed.
3. Switch on the main power breaker on control at
customer power source.
4. Push “Water” switch on control box "H". Green indi-
cator will light and solenoid will open. Allow boiler
to fill.
5. Push “OPERATE” switch. Indicator will light and
heaters will come on.
6. Allow the still to operate for 15-20 minutes. For
maximum volume of distillate, increase the flow of
cooling water to the point where only a slight wisp
of steam is visible at the condenser vent "A." If you
are using a separate source of pretreated water for
your boiler feed, adjust the boiler feed flow so that
a constant overflow from the boiler is maintained.
7. Your MEGA-PURE One Liter Water Still should
now be operational. Run the still for 4-5 hours to
cleanse itself before collecting water for use.
8. To shut your water still off push the OFF switch.
This will shut the water supply and the heaters off.
If any difficulties are encountered in operating this water still,
check all operating and assembly steps to be sure the still
was assembled and is being operated correctly. If the difficulty
still exists, consult the Troubleshooting section of this manual.
Operation
Warning
Use a properly grounded electrical
outlet of correct voltage and current
handling capacity.
Ensure that the equipment is con-
nected to electrical service accord-
ing to local and national standards.
Failure to properly connect may cre-
ate a fire or shock hazard.
Do not use in the presence of flam-
mable or combustible materials; fire
or explosion may result. This device
contains components which may
ignite such materials.
Use this device with water feed only.
Failure to comply with the above
could result in explosion and person-
al injury.
“Caution - Hot Surface. Avoid
Contact.” Glass portions of still
become hot when still is operating.
To avoid burns, do not touch hot
glass.