EASYpure unit and save it for future
use. Plug the other end of the cord
into the pump interlock on the other
EASYpure unit.
Installing The Prefilter and
Membranes
1.
Disconnect the unit from the power
supply.
2.
Pull the rear side of the door latch up
and toward the front of the unit until
the front of the door latch unhooks.
3.
Lift the front of the door latch and
open door.
Prefilter Installation
Chlorine and particulates will damage your
membranes, resulting in premature mem-
brane failure. Therefore, your EASYpure RO
uses an extruded carbon prefilter to remove
chlorine and particulates from your feed
water.
Install the prefilter as follows:
1.
Remove a new prefilter (Part Number
D50246) from its plastic bag.
2.
Wet the o-rings on both end caps of
the prefilter.
3.
Insert the upper end cap into upper
center position until it bottoms out in
the connector. (The upper end cap is
the one with the right angle turn and
the two flanges.) The two flanges on
13
I
NSTALLATION
