Barko 595 ML, Руководство оператора

Страница: 26 / 52

page 26 page 26 page 26 page 26 page 26 595ML CRL
800-00050
RADIO/CASSETTE SPEAKER CONNECTIONS RADIO/CASSETTE SPEAKER CONNECTIONS
RADIO/CASSETTE SPEAKER CONNECTIONS RADIO/CASSETTE SPEAKER CONNECTIONS RADIO/CASSETTE SPEAKER CONNECTIONS
CAUTION CAUTION CAUTION CAUTION CAUTION
To prevent short circuits or serious damage to the receiver and/or speakers: To prevent short circuits or serious damage to the receiver and/or speakers: To prevent short circuits or serious damage to the receiver and/or speakers: To prevent short circuits or serious damage to the receiver and/or speakers: To prevent short circuits or serious damage to the receiver and/or speakers:
„
Connect the speaker leads only as indicated in the wiring diagram.
„
Disconnect the machine battery's negative terminal before making speaker connections.
„
Only use speakers with impedance ratings of 4 ohms or higher and power-handling capabilities greater than the
receiver's stated power level. The unit's internal amplifier can handle a 4-ohm load on each pair of speaker leads.
„
DON'T connect two speakers to a single pair of speaker leads ("in parallel") unless both speakers each have at
least 8 ohms impedance.
„
DON'T connect the left and right speaker leads to each other or to the same speakers.
„
DON'T connect the negative speaker leads to each other, or the positive leads to each other.
„
DON'T connect any active speakers (with built-in amplifiers) to the speaker leads unless their owner's manuals
specifically state that this is acceptable.
„
Cover the ends of any unused leads with electrical tape to prevent them from touching the machine or each other,
causing a short-circuit and damage to the receiver or to the machine itself.
„
Reconnect the machine's battery.
Release Keys for Blaupunkt Radio/Cassette Release Keys for Blaupunkt Radio/Cassette
Release Keys for Blaupunkt Radio/Cassette Release Keys for Blaupunkt Radio/Cassette Release Keys for Blaupunkt Radio/Cassette
Use the two Release Keys (4" long U-shaped wire tools) that come with the unit, to pull the unit out of the face plate.
Insert them into the two holes on either end of the unit and lift. Generally the tools are included with the manufacturer's
information, in the cab pouch behind the seat. See manufacturer's information for servicing and installation procedures
also.
RADIO/CASSETTE SPEAKER RADIO/CASSETTE SPEAKER
RADIO/CASSETTE SPEAKER RADIO/CASSETTE SPEAKER RADIO/CASSETTE SPEAKER
WIRING DIAGRAM
WIRING DIAGRAM
WIRING DIAGRAM WIRING DIAGRAM WIRING DIAGRAM
INSTRUMENT PANELS CONTINUED...