Dellonda Limited, Sole UK Distributor of Baridi
Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284
757575 [email protected] www.dellonda.co.uk
Environment Protection, Waste Electrical and Waste
Electronic Equipment Regulations (WEEE)
Recycle unwanted packaging materials. When this product is no longer required, or has
reached the end of its useful life, please dispose of in an environmentally friendly way.
Drain any fluids (if applicable) into approved containers, in accordance with local waste
regulations. It is our policy to continually improve products and we reserve the right to alter
data, specifications and parts without prior notice. No liability is accepted for incorrect use
of this product. Guarantee is 12 months from purchase date, proof of which is required for
any claim.
Symptom
Solution
Unit does not operate.
Not plugged in.
Fuse/circuit breaker failure.
Turns on and off frequently.
Poor cooling.
Room temperature higher than normal.
Door opened too often.
Door not properly closed.
Temperature control incorrectly set.
Door gasket not sealing.
Not enough space around unit.
Vibrations
Check to assure unit is level.
Light does not work
Not plugged in / turned on.
Fuse/circuit breaker failure.
LED light expired
Door will not close properly
Unit not level.
Gasket distorted.
Internals out of position.
Door not properly installed after re-fitting.
•
It shows settings 0-1-2-3 with ‘0’ being OFF
and ‘3’ creating maximum cooling.
• To turn the unit on, rotate control knob from
the ‘0’ position.
•
A setting of ‘3’ will create maximum cooling
effect (approx. 5
0
C) and ‘1’ will set the working
internal temperature at approximately 15
0
C.
• When the set temperature is reached, the
compressor will power off automatically.
•
On first use, set the temperature to maximum
e.g. ‘3’ and adjust to suit once this is reached.
•
Please see Fig.1.
• Troubleshooting
• MAINTENANCE
• Remove the power plug from the supply when
performing cleaning or maintenance.
• DO NOT
use abrasive or chemical cleaning
materials on any surface of the unit.
• Wipe interior and exterior surfaces with a
damp cloth and dry thoroughly with a clean
dry cloth.
• For more soiled surfaces use a neutral
detergent, wipe down with a clean damp cloth
and dry thoroughly with a clean dry cloth.
