Barcodes Group Informs CF-PM43-1, Руководство по установке

Страница: 1 / 22

#CF-PM43 GUIDE (8/2020)
IMPRESS – Setup Guide for Informs CF-PM43-1 Thermal Transfer Printer
1
INITIAL PRINTER CONFIGURATION
When the printer is first powered up or after a factory reset the Startup Wizard will be
invoked. Additionally in order to configure the printer for your particular label stock the
Printing Wizard should be run. The Startup Wizard requires the following information:

Display Language: This defaults to English. If that is the desired language press .

Command Language: This defaults to Fingerprint. Press Direct Protocol . When
prompted press Yes .

Unit of Measure: This defaults to dots. The options are dots, inches, and mm. Press
the desired unit of measure. If dots is chosen multiply the dimensions of the label
without the backing by 203. A 4 x 1 label would be 812 x 203.
Printing Wizard: At the completion of the Startup Wizard the printer will prompt you to
run other wizards. Press Yes. Press Printing.
a.
Press Media Setup.
b. The default is Media with Gaps. If this the correct type press or press a different
type if required.
c. The default is Ribbon (TTR). If this the correct type press or press No Ribbon (DT).
d. Define your media dimensions. To modify a dimension press the field and a virtual
keypad will popup to allow you to change the setting. Press to proceed to the next
dimension.
e. Label positioning: Start adjust is the distance the printer will retract the label to
begin printing. Use the button to delete any entry before entering your settings.
A setting of -110 will feed the label to the tear-off position then retract it at print
time. You may have to adjust this for your particular stock. Press to proceed to
the next setting.
f. Stop adjust should be set to 0 if using a start adjust of -110. Press .
g. Leave print speed at the default setting. Press to complete the wizard.
h. Press the to return to the Ready screen.
Page 1 of 21