Barco XDL-4K75, Руководство пользователя

Страница: 29 / 117

3. Input & Communication
Active 3D
4 column mode (4x1 layout)
• 960 x 2160 @120 Hz
• 960 x 2400 @120 Hz
• 1024 x 2160 @120 Hz
Passive
stereo
Standard layout (1x1 layout) 3840 x 2160 @60 Hz
Passive
stereo 2 column mode (2x1 layout) 1920 x 2160 @60 Hz
3.4 Communication connections
Communication Panel
3 2 1 4 5 6 7 8 9 10 11 12 13
Image 3-7
1
WIFI antenna for wireless IP (optional)
8 RS232 for serial communication
2
12V 1A output
9
Sync Out 3D
3
Firmware update / USB download log fi les
10 Sync In 3D
4 10/100 base-T for external control over IP and Art-Net 11 Status lights
5
DMX interface input
12 IR receive sensor
6
DMX interface output
13 GSM antenna input (optional)
7
XLR input for wired projector control
12 V output
12 V output, maximum 1 A, available when projector is not in stand by.
DMX interface
DMX is used as communication bus between different devices in the light technic. Each device has an input and an output, so that
the bus can be looped between the different devices. According the standard a
fi ve wire cable with XLR connector is used.
You can use the DMX input port to connect a DMX device (DMX console) to the projector. This way you can control the projector
from that DMX device (console). The DMX output port can be connected with the next device in the loop.
Pin Description
1 Earth
2 Cold
3 Hot
4 Return - (or not used)
5 (or not used)
DMX
DMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from a lighting controller to
lighting devices. Standardized by USITT.
RS232/RS422 input
The communication interface of the XDL series projector supports RS232 and RS422 serial communication on two different types
of input connectors, a Sub-D connector and an USB connector acting as RS input when connected to an USB input of a PC.
R5906151 XDL 17/04/2018 25