Barco XDL-4K30, Руководство пользователя

Страница: 48 / 164

R5906151 /02 XDL 48
Pointing directly to the IR sensor
When using the wireless remote control, make sure you are within the effective operating distance (30 m, 100
ft in a straight line). The remote control unit will not function properly if strong light strikes the sensor window or
if there are obstacles between the remote control unit and the projector IR sensor.
25°
25°
25° 25° 45° 45°
Image 4-6: RCU to one of the three IR sensors
Using the RCU in combination with a 3D emitter
When using a 3D emitter that radiates IR beams (e. g. the optional 3D emitter that Barco provides), the IR
beams of the 3D emitter may interfere with the IR communication between the RCU and the projector.
If such interference occurs, connect the RCU to the projector using the remote cable with XLR connector. It is
also advised to turn the IR receivers of the projector off to avoid the 3D emitter interference. The IR receivers
can be turned off in the GUI:
System Settings → Communication → IR Control .
4.5 Projector Address
Projector address
Address installed in the projector to be individually controlled.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast
address.
Why a projector address?
As more than one projector can be installed in a room, each projector should be separately addressable with
an RCU or computer. Therefore each projector has its own address.
Set up an individual Projector Address
The set up of a projector address can be done via the software.
Projector controlling
When the address is set, the projector can be controlled now:
• with the RCU: only for addresses between 1 and 31.
Getting Started