Barco TransForm SCN, Руководство пользователя

Страница: 21 / 61

3. Getting started
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
________________________________________________________________________________________________
3-5
3.2.2 Graphical data
The T
RANS
F
ORM
SCN is capable to decode the analog or digital graphical output of a computer.
Formats
An analog or digital VESA source up to 1600×1200@60 Hz (UXGA) with up to 24 bpp color depth can be encoded,
please refer also to section
7.1 Technical data .
Connection
The T
RANS
F
ORM
SCN comes with a set of cables and adapters for graphical data:
•
cable DVI-I –> DVI-I
•
cable VGA 15 pin -> DVI-A
•
adapter DVI-A -> VGA 15 pin
They can be used depending on the type of the graphic connectors of the graphic card of the host PC and of the
monitor.
For the connection of the host PC with the DVI in [9] connector of the T
RANS
F
ORM
SCN the provided cables DVI-I –
DVI-I or VGA – DVI-A can be used, depending on the connector type of the host PC.
If you want to loop through the signal and display it on a monitor or other displaying device, connect the DVI out
[10] connector with the displaying device. For that purpose you can use the so far used cable. If this cable has a
VGA plug you can use the DVI-A -> VGA 15 pin adapter to connect it to the T
RANS
F
ORM
SCN.
10 9
Figure 3-4
connecting a graphical data source
To be able to use DDC information of the monitor, it must be connected before the
TransForm SCN is connected to the power supply.
3.2.3 Network
For the network connection the network adapter on the back of the T
RANS
F
ORM
SCN is used. It consists of an RJ45
connector suitable for a 10/100 Mbps connection.
Connection
Plug the network cable into the LAN adapter [14] on the rear of T
RANS
F
ORM
SCN.
Network requirements
property requirement
speed 100 Mbps full duplex
port switched (no hub)
bandwidth capacity to transport a 30 Mbps T
RANS
F
ORM
SCN stream without packet loss
Table 3-1