Barco SLM R12 Plus, Руководство по обслуживанию, Страница: 40 / 281

7. IR Transmitter RC-5 Coded R763569
7.2 Access to the IR Transmitter Board
Handle as follows:
1. Remove the screw (1) , using a Torx Screwdriver (T10), holding top and bottom housing together.
2
3
1
Image 7-3
Access to IR transmitter board
2. Remove the battery cover (2&3) and disconnect the battery.
3. Separate the top from bottom housing as follows:
Important
: The top housing clicks onto the bottom housing onto 4 points on both long sides. To remove the top housing, release
the 4 click points (A..D) on one side of the remote control.
- Insert a flat screwdriver in the groove near to the click point.
1
2
A
B
C
D
Image 7-4
Access to IR transmitter board
- Push a little pressure (1) on the screwdriver (to unlock) and lift up (2) the top housing on that specific click point.
- Repeat the same action on the four click points of the same side.
4. Remove the bottom housing.
7.3 Battery Plug in
Place of the battery on delivery
The battery for the RCU is not yet installed on delivery, to save the battery life time, and is placed in the upper compartment (B)
(image 7-5) inside the RCU.
How to plug in!
1. Press the battery cover (A) lock (1) inwards and simultaneously lift up the cover (2) for removal.
38 R5976820 SLM R12+ PERFORMER 08/03/2005