Barco S3 series, Руководство пользователя, Страница: 260 / 538

8. Updating firmware
8.1 Upgrading fi rmware using the USB port
Necessary tools
USB drive (Not supplied by Barco) formatted in FAT32.
How to upgrading fi rmware
1. Ensure that your fl ash drive is formatted to use the FAT32 fi le system. If necessary, reformat the drive as described in the following
section “Formatting the fl ash drive”.
2. Prepare the fl ash drive with the upgrade fi le as describe below in the section “Preparing the fl ash drive with the upgrade fi le”
Note: Upgrading software with the USB port requires the “em_update_vp.xx.xx.tar.gz” fi le to be within a directory named EM
(or E2).
3. When the drive is ready, refer to the chapter “Performing the fi rmware upgrade using the USB” describe below for the upgrade
procedure.
C
AUTION
:
Reformatting the fl ash drive erases existing data. To avoid losing data, download to a computer
or a secure site any fi les you wish to keep, then format the drive.
Formatting the fl ash drive
1. Insert the fl ash drive into a Windows PC or laptop’s USB port.
2. Select a Windows Explorer or a panel allowing an overview on the disk drives and the hardware connected to your computer
(e.g. Start > Computer on Windows 7 or Start > My Computer on Windows XP).
3. On this view, right-click the drive that represents the fl ash drive.
4. Select Format from the menu that appears.
The Format Disk screen appears.
Image 8-1
Format Disk screen
5. Select FAT32 as the fi le system, and Quick Format under Format Options , as shown above in the Format Disk screen illustra-
tion.
6. Click Start .
A message appears, warning that data will be erased during the formatting process.
7. Click OK to continue.
A con fi rmation message appears after a few seconds. The fl ash drive is now ready to use
Upgrading software with the USB port requires the “em_update_vp.xx.xx.tar.gz” fi le to be within a directory
named EM (or E2).
256 R5905948 EVENT MASTER DEVICES 17/07/2017