Barco S3 series, Руководство пользователя

Страница: 227 / 538

7. System Setup
7.4 Return to factory default
General
Prior to performing any setup procedures, it is recommended that you perform a factory reset — in order to reset all input, output
and source mappings to their default values.
Particularly for customers in the events and rental marketplace, this procedure guarantees that any previous input setups and mem-
ory registers (e.g., those that may have been programmed by other users) are completely cleared from system memory.
If you are continuing an event (for example, day two of a three-day event), you do not need to perform a factory
reset. However, if you do elect to perform a factory reset, ensure that you have backed up your system. for
details, please refer to the procedure "Backing up the system", page 228.
Prerequisite
• Ensure that you are familiar with the Reset Menu . For details on all menus, please refer to chapter "Restoring Factory Default
Settings", page 83.
Restoring factory settings
To restore all default settings to the Event Master series processor, use the following procedure:
1. Select
Factory Reset from the Setup Menu.
The Factory Reset Menu appears.
2. Select Factory Reset to reset the entire system to its factory default values. Remember that all data will be lost.
Or,
Select
Factory Reset, Save IP to reset the entire system to its factory default values, but retains the IP address of the unit.
A prompt appears, asking if you want to clear all con fi gurations.
3. Press SEL.
The system turns off, then it reboots.
R5905948 EVENT MASTER DEVICES 17/07/2017 223