Barco - RHDM-2301 - User manual ____________________________________________________ 51
Full functionality description
The Fault LED lights up when a hardware failure is detected by the display unit. The Fault
LED does not refer to the display unit operating in non-calibrated mode. When the Fault
LED lights up red, the Cal/Err indicator LED on the bezel will also light up red.
IMPORTANT
:
When an error occurs, consult the OSD submenu “Status controller” to check the warning and/or fault
messages.
NOTE
:
When the display unit starts-up from a hard standby status, the Fault LED lights up during the
initialization. When the control panel is fully operational and when the display unit did not detect
problems during start-up, the Fault LED will go out.
4.2.4 Image adjustment knobs
Figure 31: Image adjustment knobs
Pressing the knob (
) sets the value back to the calibrated (preset) value.
NOTE
:
•
When the value of the image adjustment knobs deviates from the calibrated value, the display unit
operates out of the calibrated range. The LED above the knob will light up orange.
Function
Description
Background
Adjusts the background (from -127 to +128). The background is equiv-
alent to video offset and is expressed in 8-bit steps.
Calibrated value: 0 (default)
!
Picture
Adjusts the picture (from 45 to 200). The picture is expressed in cd/m
2
(nit).
Calibrated value: 100 (default)
The calibration of the color gamut, white point and gamma is main-
tained when the picture is between 45 cd/m
2
and 150 cd/m
2
.
#
Saturation
Adjusts the saturation (from 0 to 250). The saturation is expressed in
percentage (%).
Calibrated value: 100 (default)
$
Hue
Adjusts the hue (from -90 to +90). The hue is expressed in degrees (°).
Calibrated value: 0 (default)
