Barco - RHDM-2301 - User manual ____________________________________________________ 15
First operation
2.3 Switch on the display unit
This section is intended for a user who has no experience with the display unit and
describes the standard settings that are necessary to get the display unit up and running.
Please check the chapter with the “full functionality description” to find detailed
information on each part and each function of the display unit.
Figure 2: Overview indicator lights
NOTE
:
The display unit has a certain delay time between powering up and displaying an image on the screen
(20 seconds). The delay time originates from several internal checks and calibrations that are
performed to guarantee the correct display of the image. When in doubt about the status of the display
unit, please read the troubleshooting in the addendum.
•
Check the indicator lights to verify the status of the display unit.
When no
indicator lights are lit, check the installation instructions in the addendum to power
up the display unit (check if the power switch at the back is switched on).
Power LED = green: Display unit is switched on – no further actions are nec-
essary.
Power LED = green and Standby LED = orange: Display unit is switched on
(soft standby) – the panel and backlights are switched off. Press (
)
on
the control panel to activate the panel and backlights.
Power LED = orange: Display unit is switched off (hard standby) – press (
)
on the control panel to switch the display unit on. The Power LED will light
up green.
1
Power LED (green or orange)
2
Standby LED (green or orange)
3
Calibration/Error LED (orange or red)
1
2
3
