Barco R9040004, Руководство пользователя

Страница: 99 / 111

7. Service Mode
The projector selects the last used memory bank.
2. Press ENTER to continue.
3. Push the corresponding digit (between 1 and 8) of a non existing memory bank e.g. bank 4.
Note: The memory banks can be created in random order, it is possible first to create bank 4 and later on bank 2.
4. Make the necessary adjustments e.g. change the vertical frequency from 60 Hz to 50 Hz.
Due to the vertical frequency change the projector will create a new block with bank number 4.
How to Recall a Memory Bank?
When Memory Bank is On, an on-screen display with the last used memory bank settings will be displayed when selecting a source,
to switch to another Memory Bank:
1. Press
ENTER to select the next memory bank in increasing order.
The on-screen display will be updated.
Or,
Use the digit keys to enter the number of the desired memory bank.
The on-screen display will be updated.
7.5.7 Flyback Turnover Point
What can be done?
The horizontal flyback time for horizontal frequencies can be long or short. The turnover point from long to short can be set by the
user.
How to adjust the Flyback Turnover Point?
1. Push the ↑ or ↓ keys to highlight Flyback Turnover Point and press ENTER to select.
COMMON SETTINGS
DYNAMIC ASTIGMATISM
GAMMA CORRECTIONS
CRT RUN IN CYCLE
CRT DRIVE MODE
MEMORYBANKS: ON
FLYBACK TURNOVER POINT
MENU POSITION: STANDARD
OPTION 1: OFF
REAL TIME CLOCK
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 7-63
The Flyback Turnover Point menu will be displayed, the actual Flyback Turnover Point Frequency will be filled in.
2. Use the cursor keys to select the desired digits and enter the new value using the digit keys on the RCU.
FLYBACK TURNOVER POINT
Enter new frequency:
0 9 0 kHz
Use the
←
or
→
to select,
and reprogram with
numeric keys.
Lowest point is 90 kHz.
Highest point is 130 kHz.
<ENTER> to confirm
<EXIT> to return.
Menu 7-64
Note: The Flyback Turnover Point Frequency should be somewhere between 90 kHz and 130 kHz.
3. Press ENTER to activate the Flyback Turnover Point Frequency.
7.5.8 Menu Position
What can be done?
The bar scale menu, warning and message boxes can be displayed in the right lower corner or in the middle of the screen.
R5976633 BARCO GRAPHICS 908 / BARCO REALITY 908 05/06/2003 95