Barco R9040004, Руководство пользователя

Страница: 77 / 111

7. Service Mode
2. Press ENTER to reset the Run Time.
3. Press EXIT to return to the Projector Set-Up menu.
7.3.4 Change Password
What can be done?
The password code (4 digits) can be changed to a new one. This item is password protected. First the actual password should be
entered before continuing.
Password function is only active if the jumper on the controller is in the ’On’ position. Contact a qualified
BARCO technician to activate the password if needed.
The default password is 0000.
How to Change the Password?
1. Push the ↑ or ↓ keys to highlight Change Password and press ENTER to select.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
ABL CONTROLLER
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 7-9
Note: If it is the first time you enter a password protected item, enter your password and press ENTER .
The current Password will be displayed in the Password menu.
PASSWORD
Enter new password:
0000
Use
←
and
→
to select,
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
Menu 7-10
2. Push the ← or → keys to highlight the digit to be changed.
3. Press a numeric key to enter the new digit.
4. Repeat step 2 till 3 for the other digits.
5. Press ENTER to save the new password.
Before saving the new password, a confirmation screen will be displayed.
6. Press ENTER to confirm, press EXIT to cancel the saving.
7.3.5 Change Projector Address
What can be done?
Every projector requires an individual address between O and 255. This address can be set by the software.
R5976633 BARCO GRAPHICS 908 / BARCO REALITY 908 05/06/2003 73