Barco R9006332B1, Руководство пользователя

Страница: 19 / 92

RLM W14 17/04/2017
11
2.General
2.6 Projector air inlets and outlets
Ventilation inlet:
The internal cooling fan draws cool air from the ventilation inlet into the projector.
Ventilation outlet:
The hot air generated inside the projector is dispersed through the ventilation slot. Make sure the ventilation slot is free from
obstruction.
Ventilation inlet
Ventilation outlet
2.7 Installation process overview
Quick setup
The following steps describe briefly how to setup your RLM W14 projector in a table mount front projection. Note that each
step refers to a corresponding procedure, which is more detailed and illustrated.
4. Install the batteries of the remote control. See
page 22: 4.1 Remote control unit (RCU)
5. Place the projector on a solid table in front of the screen at the expected throw distance. Adjust the feet to ensure that
the projector is installed at right angles (horizontally and vertically) with the screen. See page 31: 4.6 Alignment of a
table mounted projector and page 35: 5.7 Adjusting the lens by horizontal and vertical lens shift
6. Connect the projector with the local power net. See
page 30: 4.5 Connecting the projector with the power net
7. Select and install an appropriate lens, which covers the throw ratio ( = screen size / projector screen distance). See
page
9: Positioning the projector
8. Switch ON the projector. See
page 30: 4.5 Connecting the projector with the power net
9. Connect your source to the appropriate input module. See
page 13: 3.3 Input and Communication
10. Zoom and shift the lens until the image is properly projected on the screen, Do this by using the “ZOOM” and “FOCUS”
key on the remote control unit or on the local keypad. If necessary, level the projector from side to side by turning the
adjustable feet in or out. See
page 28: Lens zoom .