Barco R9004120, Руководство пользователя

Страница: 53 / 105

8. Image Settings
Different steps to create a viewport.
Image 8-2
Creation of a viewport, views on the screen while adjusting
A Input signal
B Desired image on the screen (viewport)
C Horizontal start position
D Vertical start position
E
Set up of viewport width
F Set up of viewport height
Viewport creation only works correctly when the
total pixels
and
total lines
settings in the viewport menu are
more or less correct: The other settings (Horizontal start, horizontal size, vertical start, vertical size) depend
on these two settings. The software does not allow ’horizontal start’ + ’horizontal size’ to be larger than ’total
pixels’. So, if the menu does not allow you to shift the image far enough, or set the image wide enough, it is
very likely that the total amount of pixels is set too low. The same goes for the vertical parameters.
R5976672 SOLARIS LC40 01042004 49