Barco Prometheus III, Руководство по установке

Страница: 119 / 200

R5906897 /02 Prometheus III 119
Situation Solution
Multiple disks failed (multiple red LEDs) + RAID
broken .
Note: The disk status (RAID broken) can be
retrieved via the (Web) Commander. See user guide
of the (Web) Commander.
1. Switch off the power.
2. Replace all defect HDDs with approved models of
the same storage capacity. See procedure
“ Removing a HDD from the ICMP ” , page 124,
and “ Installing a HDD into the ICMP ” , page 125.
Ensure to insert the HDDs firmly.
3. Switch on the power.
4. Start “ RAID Initialize ” . See user guide of the
Communicator.
Result: a new empty RAID is created.
All HDD LEDs remain off + Error 10580 “ local
storage not available ” .
Note: The disk status (Error code) can be retrieved
via the (Web) Commander. See user guide of the
(Web) Commander.
1. Switch off the power.
2. Reseat all HDDs. See procedure “ Removing a
HDD from the ICMP ” , page 124, and “ Installing a
HDD into the ICMP ” , page 125. Ensure to insert
the HDDs firmly.
3. If problem remains try “ RAID Initialize ” . See user
guide of the Communicator. Note that all content
will be lost!
4. If problem remains contact Service for further
instructions.
In case the ICMP has to be returned to factory (e.g. for repair) the non defective HDDs should be
removed and kept.
8.11 ICMP device certificate
Purpose of the Barco ICMP device certificate
The device certificate (*.pem) of the Barco ICMP is a digital certificate signed by Barco which is required when
ordering the KDM to play a DCP that is ingested on the ICMP. The device certificate is stored inside the ICMP
and on a web server.
The (WEB) Commander or Communicator can be used to retrieve the device certificate directly from the
ICMP. To retrieve the device certificate from the website the QR (Quick Response) code can be used. See
procedure
“ Obtaining the Barco ICMP certificate ” , page 123.
ICMP