Barco PHWU-81B, Руководство пользователя и инструкция по установке

Страница: 84 / 143

7. Initial network settings
→ The setting change dialog is displayed. After the dialog disappears, the NETWORK menu is displayed.
→ It may take some time to re fl ect the settings.
7.5 Setting the control system
How to set
1. Display the NETWORK menu.
2. Press the ▲ or ▼ key to select CONTROL SYSTEM .
CONTROL SYSTEM STANDARD
Image 7-19
3. Press the ENTER key.
: CONTROL SYSTEM
OK : ENTER CANCEL : MENU
STANDARD
Image 7-20
4. Press the ◄ or ► key to select STANDARD , AMX , or CRESTRON .
STANDARD Select this setting when using Projector Toolset, or RS-232C commands via LAN terminal.
AMX Select this setting when using the controller of AMX.
CRESTRON Select this setting when using the controller or software of Crestron Electronics, Inc.
Important: PJLink™ works regardless of the setting of CONTROL SYSTEM.
5. Press the ENTER key.
It may take some time to re fl ect the settings.
7.6 Initialization of Network Settings
How to initialize
1. Display the NETWORK menu.
2. Press the ▲ or ▼ key to select NETWORK RESET .
NETWORK RESET OK
Image 7-21
3. Press the ENTER key.
Con fi rmation dialog appears.
4. Press the ENTER key again, and the Network Settings can be initialized (except for IP CONFIG).
To cancel the initialization, press the MENU key.
It may take some time to re fl ect the settings.
7.7 How to Use Network Function
Overview
• When connecting a computer and projector with LAN, con fi gure the both IP Addresses in the same network group.
If connecting in different network group, be sure to use a router. As for the settings of a router, ask the network administrator.
• Con fi gure the IP CONFIG correctly. If the settings are not correct, the communication may be unavailable. For the detail,
consult the network administrator.
• Depending on the settings of standby mode of the projector, LAN function may be unavailable.
80 R5905597 PHXX SERIES 20/05/2014