Barco PH series, Руководство пользователя и инструкция по установке

Страница: 50 / 143

5. Advanced menu
Item
Setting
Function
DVI LONG CABLE AUTO Select this option for normal use.
MANUAL
Use to adjust the amount of transmission signal correction when a
long DVI cable is used.
REMOTE 1 MODE
ENTER
Select when controlling the projector by a control panel connected to
the REMOTE 1 IN terminal.
PIN 1 GND Unchangeable. (Fixed.)
PIN 2 POWER / NONE Select POWER or NONE.
PIN 3 COMPUTER 1
PIN 4 COMPUTER 2
PIN 5 VIDEO
PIN 6 S-VIDEO
PIN 7 DVI
You can assign COMPUTER 1, COMPUTER 2, VIDEO, S-VIDEO,
DVI, HDMI, SDI (for PHWU-81B only), or NONE to each pin. Though
the assignment can be duplicated, the pins so assigned become
invalid and their settings are displayed with asterisks at both ends
(like “*COMPUTER 1*”).
PIN 8 BLANK / NONE Select BLANK or NONE.
PIN 9 ON/OFF Unchangeable. (Fixed.)
RESET
OK
Settings are reset to the defaults.
FILTER MENU
ENTER
The fi lter menu for the following settings is displayed.
CLEANUP PERIOD
24H / 1 WEEK / OFF
You can set the fi lter cleaning interval.
MANUAL CLEANUP
OK
Select this option to clean the fi lter immediately.
• When STANDBY MODE in the INSTALLATION 1 menu is LOW, you cannot select REMOTE 1 MODE.
5.6 Multi-Screen menu
Overview
IMAGE INSTALL1 INSTALL2
MULTI-
SCREEN
FEATURE SIGNAL NETWORK INFO
EDGE BLENDING
SETTING
OFF
OFF
EDGE ADJUST
COLOR MATCHING
SETTING
MEASURED DATA
MANUAL
MEASURE
Image 5-16
Item Setting Function
EDGE BLENDING OFF Select when using the projector alone
ON Select when using the projector to con fi gure the multi-screen
consisting of multiple projectors.
The following settings in the SETTING become enabled to make the
overlapped area of the displayed images unnoticeable.
SETTING
EDGE ADJUST
Use to make the overlapped area of the screens unnoticeable in the
multi-screen application. Use this setting to select the edges to be
overlapped or to set the overlapped areas.
BLACK LEVEL
In the multi-screen application, the black level in the areas where
images are overlapped will become bright. So, use this setting to
adjust the black level in non-overlapped areas.
BRIGHT UNIFORMITY
CORRECTION Use to correct non-uniformity in the screen brightness of the single
projector to facilitate edge blending.
46 R5905597 PHXX SERIES 20/05/2014
Downloaded From projector-manual.com Barco Manuals