Barco OVERVIEW D 50", Руководство по установке

Страница: 100 / 120

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006 September 2006 September 2006 September 2006 ________________________________
________________________________ ________________________________ ________________________________________________________ ________________________ ________________________ ________________________8-32
The following table lists the article number of the illumination unit and the required lamp driver:
R764226 Compact
R764581 Powerpack 100W
R764582 Powerpack 120W
Make sure to have the correct settings! Otherwise color artifact and wrong control parameters
will affect the performance of the projector! SXGA+ projectors ONLY run with Power Pack
lamp driver!
Please keep in mind:
In case of the Powerpack lamp drivers, the following feature is normal and cannot be avoided: During ignition of
the lamp some color alternation on the screen will show up for about one second. This behavior can be observed
•
When the projector is in cold standby and is switched to hot standby
•
When the projector is in cold standby and the active lamp is changed by the operator
•
When the projector is in Auto Switch Mode, and the projector initiates the change of the active lamp.
The alternation speed depends on the current projector timing.
8.5.7 No Source Counter
Figure 8-45
Service|Maintenance|No Source Counter
In case of color bar problems (the projector suffers from loss of signal although the sources are connected, this
command can be selected to check how often the signal has been lost.
A dialog opens which shows the actual value:
igure 8-46
No Source Counter to check how often the signals has been lost