Barco NW-12, Руководство пользователя

Страница: 163 / 181

7. Advanced
7.11.4.2 Warning messages
What can be done?
It is possible to block some Warning messages during projector runtime. The table below gives an overview of those messages that
can be suppressed during runtime.
Warning message Sim 5W Galaxy NH-12
Galaxy NW-12
Description
NO SIGNAL
x x
In case no incoming Sync is detected
Lamp error icon
x
In case of an actual lamp or LPS problem
Lamp runtime warning
x x
Max lamp runtime almost reached
Lamp runtime exceeded
x x
Max lamp runtime exceeded
Desktop resolution not valid
x
Desktop input signal resolution is out of
speci
fi cation.
For safety reasons, the warning messages Lamp runtime warning and Lamp runtime exceeded will always
pop up during start-up of the projector. They can only be suppressed during projector runtime.
How to enable/disable Warning Messages?
1. Press MENU to activate the Tool bar
2. Press → to select the Service item
3. Press ↓ to Pull down the Service menu
4. Use ↑ or ↓ to select Operation options
5. Press → to pull down the Operation Options menu
6. Use ↑ of ↓ to select Warning Messages
7. Press → to pull down the Warning Messages menu
8. Use ↑ or ↓ to select On or Off
9. Press ENTER to con fi rm
Image 7-194
A white bullet shows the active setting
R59770286 NW-12 25/09/2008 159