Barco Nio 3MP LED, Руководство пользователя

Страница: 25 / 52

K5902157-01 Nio 3MP LED Display
25
To quickly switch the viewing mode without having to enter the OSD menu, touch the left and right
key at the same time during normal operation.
The diagnostic mode should always be selected when the Nio 3MP LED Display is intended to be
used in a diagnostic environment.
To select a viewing mode:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Calibration menu.
3. Enter the Viewing Mode submenu.
4. Select Diagnostic/Text as desired and confirm.
4.10 Display functions
About display functions
Native, uncorrected panels will display all grayscale/color levels with luminance increments that are not
optimal for crucial diagnostic information. Studies have shown however, that in medical images certain
grayscale/color parts contain more diagnostic information then others. To respond to these conclusions,
display functions have been defined. These functions emphasize on these parts containing crucial diagnostic
information by correcting the native panel behavior.
The available display functions for your Nio 3MP LED Display are:
• Native: If you select Native, the native panel behavior will not be corrected.
• Dynamic Gamma 1.8 or 2.2 : These are gamma functions that are shifted to take into account the non-zero
luminance of an LCD panel when driven with a “ black ” signal. They are especially useful in CT applications
to improve the perception of low Hounsfield values.
• DICOM: DICOM (Digital Imaging and Communications in Medicine) is an international standard that was
developed to improve the quality and communication of digital images in radiology. In short, the DICOM
display function results in more visible grayscales in the images. Barco recommends selecting the DICOM
display function for most medical viewing applications.
• User: This display function will be automatically selected when display functions are defined by MediCal
QAWeb.
• Gamma 1.8 or 2.2 : Select one of these display functions in case the display is to replace a CRT display
with a gamma of 1.8 or 2.2 respectively.
The settings of the display must be adapted to suit the requirements of the visualization software. In
case of doubt, please contact the vendor of the visualization software.
To select a display function:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Calibration menu.
3. Enter the Display Function submenu.
4. Select one of the available display functions and confirm.
4.11 Color presets
About color presets
Color presets are only available for the color version of the Nio 3MP LED Display.
The available color preset settings for your display are:
• Clearbase: Simulation of the clearbase film color temperature.
Advanced operation