Barco MDSC-8255 12G, Руководство пользователя

Страница: 22 / 72

R5913964 /00 MDSC-8255 22
Main
(1)
2nd
(2)
2 1
3 4
MP3
1
4
6
7
8
9 10
5
+5VDC
Image 3 – 2
DisplayPort VESA DP 1.2 certified cables for 5.4 Gbps HBR2 with a length of up to 2 m are
recommended.
Premium certified HDMI 2.0 cables with a length of up to 3 m are recommended.
3G-SDI Belden 1694A cables with a length of up to 50 m and 12G-SDI Belden 4855R cables with a
length of up to 30 m are recommended.
The DVI output must be enabled in the OSD menu (please refer to “ DVI output ” , page 48).
A subset of the commands of the remote control protocol is also available on a new DDC protocol
on DVI and DisplayPort1 auxiliary channel.
3.1.3 MDSC-8255 12G
To connect the interfaces
1. Connect one or more video source(s) to the corresponding video inputs of the display. For a list of
supported video inputs, see “ Technical specifications ” , page 64. See “ SDI config (only for MDSC-8255
12G) ” , page 40 about the possible SDI configuration modes.
2. Screen image clone: The entire active image on the screen (including OSD) can be duplicated to a FHD
(1080p/1080i) signal on the DVI output connector, to which an additional DVI video sink can be connected.
3. Connect the USB2.0 type B interface with a workstation to use the remote control protocol, to update the
display firmware, or to be able to connect any USB peripheral with the USB interfaces of the display.
4. Use any USB peripheral (keyboard, mouse, webcam, ...) by connecting it to the available USB interface(s).
5. Con5 VDC - 2A power out for accessory (Mating connector HIROSE RP34L-5PA- 2SC(1857)(71)).
Installation