Barco MDRC-2122 WP, Руководство пользователя

Страница: 29 / 41

7. Important information
10
China Energy Label
If there is a China Energy Label on your packaging or product, the product meets the following energy
requirements corresponding with the energy ef
fi ciency level on the label.
按照中国
<<
能源效率
标识
管理
办
法
>>
In accordance with The Regulation
of the Implementation on China
Energy Label
本
显
示器符合以下要求
This monitor is compliant with the
following requirements
本
显
示器符合以下要求
This monitor is compliant with the
following requirements
能源效率等
级
Energy Ef fi ciency Level
1 2
能源效率
Energy Ef fi ciency (cd/W)
> 1.05 > 0.85
关闭
状
态
能耗
Energy Consumption in off mode
(W)
< 0.5 < 1.0
执
行的能源效率国家
标
准
编
号
Code of National Standard applied
GB 21520 GB 21520
7.3 Regulatory compliance information
Indications for use
This display is an AMLCD display designed for viewing medical X-ray images. This unit should not be
used near patients (where patients are likely to be in unconscious condition) and should be kept outside
of 1.83 m perimeter and 2.29 m vertical.
FCC class B
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference re-
ceived, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this device does cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
K5903049 EONIS 25/06/2015 27